Enmet Ozone Generator Instrukcja Użytkownika

ENMET CorporationPO Box 979Ann Arbor, MI 48106-097980003-118MCN-282, 05/14/04Ozone GeneratorManual

ENMET Corporation OZONE GENERATOR6Ozone Output Adjustment:If the output is not the required level:Verify that the flow meter is set to 0.5 lpm.When th

OZONE GENERATOR ENMET Corporation7WARRANTYENMET warrants new instruments to be free from defects in workmanship and material under normal use for a pe

ENMET Corporation OZONE GENERATOR8Notes:

PO Box 979680 Fairfield CourtAnn Arbor, Michigan 48106-0979734.761.1270 Fax 734.761.3220Returning an Instrument for RepairENMET instruments may be ret

Repair Return FormMailing Address:ENMET CorporationPO Box 979Ann Arbor, Michigan 48106Shipping Address:ENMET CorporationAttn: Repair Department680 Fa

Table of Contents1.0 INTRODUCTION ...

OZONE GENERATOR ENMET Corporation11.0 IntroductionNOTE: All specifications stated in this manual may change without notice.1.1 UnpackUnpack the OZONE

ENMET Corporation OZONE GENERATOR22.0 OZONE GENERATOR Features SectionSee Figure 1 for location of featuresFeature DescriptionFlowmeterThis Flowmeter

OZONE GENERATOR ENMET Corporation3OperationOZONE GENERATOR CALIBRATION KIT: part numbers04056-0800-2(110 VAC)04056-0800-3(220 VAC).WARNING: This dev

ENMET Corporation OZONE GENERATOR4Check for Leakage:a) Insert an unused sealed detector tube in the pump inlet; do not break the tips.b) Line up the

OZONE GENERATOR ENMET Corporation5Pump MaintenanceIn normal use, the pump should be taken apart, cleaned and re-lubricated after 100 to 200 samples ha