Enmet EX-5130 Instrukcja Użytkownika Pobierz pdf (Strona 7)

EX-5130-IS ENMET Corporation

4.0 Operation of the EX-5130-IS

It is best to have the EX-5130-IS transmitters powered up and operational for 24 hours before applying calibration or

test gas to them.

When the EX-5130-IS transmitter is first powered up, it goes through a series of momentary screens, which identify

the instrument model number, serial number and software revision. After all of the momentary screens have been

displayed, the instrument arrives at the Main Gas Display showing the gas concentration and unit of measurement.

Depending on transmitter configuration and calibration condition, the furthest right character in the display may flash a

letter indicating the instrument status. See the Section 4.1.2 below.

4.1 Start up

Typical Start Up

When power is supplied to the EX-5130-IS, the S/T will display the following sequence of information:

OTE

Software revision may cause variations of display output.

Example of Display Function

The instrument: Model

5130

Note Toxic is not displayed

The instrument: Serial Number

The instrument: Software Revision

IF the right most character is a flashing

The instrument is in Warm-up mode

 This should last about 1 minute

 The Signal Output is held at 4mA during warm-up

For Toxic Gas

The instrument: Normal Display Mode

Measurement of target Gas

IF the right most character is a flashing

C, F, P

See Section 4.1.2

5130

1256

S/W X.X

0ppm

0ppmW

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Brak uwag

Enmet EX-5130 Instrukcja Użytkownika Strona 7